Skip to Content

Changes for page 3.3 Control

Last modified by Admin on 2025/04/09 12:14
From version 42.1
edited by Admin
on 2025/02/19 14:58
Change comment: There is no comment for this version
To version 39.3
edited by Admin
on 2025/02/17 17:25
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -315,7 +315,8 @@
315 315  The Main contactor algorithm supports the following modes:
316 316  
317 317  * Always on;
318 -* Automatic.
318 +* Automatic;
319 +* On demand.
319 319  
320 320  In “Always on” mode main contactor closes if all the following is true:
321 321  
... ... @@ -621,7 +621,7 @@
621 621  
622 622  A balancing resistor is disconnected from the cell if any of the following conditions are met:
623 623  
624 -* the voltage on the cell is less than the balancing stop voltage;
625 +* the voltage on the cell is less than the balancing start voltage;
625 625  * the difference between the voltage on the cell and the minimum voltage among the battery cells is less than the balancing stop threshold.
626 626  
627 627  If the “High logic temperature” occurs, then the balancing of the cells connected to the overheated BMS Logic device will not be performed.
... ... @@ -628,7 +628,7 @@
628 628  
629 629  The BMS Main 3 can enable the cell balancing by the external “Balancing request” signal. Balancing process will be started to cells which the voltage is higher than the balancing start voltage and the difference between the cell voltage and the minimum voltage among all the cells is greater than the balancing stop threshold.
630 630  
631 -BMS Main 3 can force a cell balancing, if its voltage is higher than estimated value.
632 +BMS Main 3 can force a cell balancing, if its voltage is higher than
632 632  
633 633  To change the cell balancing parameters, select the "Control → Cell balancing" section:
634 634