Skip to Content

Changes for page 3.3 Control

Last modified by Admin on 2025/04/09 12:14
From version 30.2
edited by Admin
on 2024/12/26 16:40
Change comment: There is no comment for this version
To version 31.1
edited by Admin
on 2024/12/26 16:41
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -391,7 +391,7 @@
391 391  
392 392  === Discharging status ===
393 393  
394 -To change the parameters of charging process status, select the "Control → Discharging status" section:
394 +To change the parameters of discharging process status, select the "Control → Discharging status" section:
395 395  
396 396  [[image:1735064980481-209.png||data-xwiki-image-style-alignment="center" data-xwiki-image-style-border="true" height="102" width="800"]]In this section:
397 397  
... ... @@ -401,12 +401,14 @@
401 401  * Voltage to reset the “Ready to discharge” – a tolerant voltage level on the cell, V; if all cells voltages are above the tolerant level, the “Ready to discharge” signal is set;
402 402  * Errors 1, 2 to clear the "Ready to discharge" – bitfields to choose the errors which will clear the "Ready to discharge" signal.
403 403  
404 -=== Precharge () ===
404 +=== Precharge ===
405 405  
406 406  The BMS Main 3 device can control the precharge contactor. The precharge contactor is used to charge the intermediate capacity with low current and usually placed with the limiting resistor in parallel to charging or discharging contactor.
407 407  
408 408  BMS Main 3 device detects errors while pre-charging the load capacity by monitoring the current and voltage difference before and after contactors. Also BMS can measure the power dissipated on precharge resistor and generate an error if it greater than configured limit.
409 409  
410 +TBA
411 +
410 410  To change the parameters of precharge contactor, select the "Control → Precharge" section:
411 411  
412 412  [[image:1735065073836-743.png||data-xwiki-image-style-alignment="center" data-xwiki-image-style-border="true" height="160" width="800"]]
... ... @@ -591,6 +591,8 @@
591 591  * Independent (Always) - Charge/Discharge contactor is always closed if there is no errors;
592 592  * Independent (on Charge request or Discharge request) - Charge/Discharge contactor is based on its own controller that listen to Charge and Discharge requests and closes if one of these signals occurs.
593 593  
596 +TBA
597 +
594 594  (% class="box infomessage" %)
595 595  (((
596 596  **Note: **when errors occur in the system, the **Charge/Discharge **contactor opens either immediately or with the delay T,,off,, (depends on the settings described below).