Skip to Content

Changes for page 3.1 General information

Last modified by Admin on 2025/03/27 15:20
From version 7.3
edited by Admin
on 2024/12/26 17:18
Change comment: There is no comment for this version
To version 7.4
edited by Admin
on 2024/12/26 17:19
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -6,19 +6,17 @@
6 6  
7 7  This document describes how to configure the BMS Main 3 device. Configuring can be done using the ElectricDeviceMonitor above the 1.18.0 (available by the [[link>>url:http://movicomelectric.com/wa-data/public/site/app/ElectricDeviceMonitorSETUP.exe]]) via
8 8  
9 -USB, CAN bus (Systec, PEAK, Marathon and USB-CAN adapters are supported) or TCP connection (BMS Wi-Fi or BMS LANmodule must be installed on BMS Main 3).
9 +* USB;
10 +* CAN bus (Systec, PEAK, Marathon and USB-CAN adapters are supported);
11 +* TCP connection (BMS Wi-Fi or BMS LANmodule must be installed on BMS Main 3).
10 10  
11 -The USB-miniUSB cable (connector X10) is used in this example to connect the BMS Main 3 device to a PC. After connecting, the device is identified as a device with a serial interface (COM port) as in the figure below:
13 +After connecting device to the PC, launch ElectricDeviceMonitor, select "Unified monitor" in the main program window:
12 12  
13 -[[image:1733320484262-545.png||data-xwiki-image-style-alignment="center" height="333" width="482"]]
14 -
15 -To connect to the device, launch ElectricDeviceMonitor, select "Unified monitor" in the main program window:
16 -
17 17  [[image:1735233230234-960.png||data-xwiki-image-style-alignment="center" data-xwiki-image-style-border="true" height="340" width="450"]]
18 18  
19 19  Choose the connection type and set up connection settings:
20 20  
21 -* Serial port (USB)
19 +* Serial port (USB): select the COM port
22 22  
23 23  [[image:1733320484267-118.png||data-xwiki-image-style-alignment="center" height="248" width="450"]]
24 24