Skip to Content
Last modified by Admin on 2025/05/12 10:19
From version 1.5
edited by Admin
on 2024/11/20 15:47
Change comment: There is no comment for this version
To version 2.1
edited by Admin
on 2024/11/20 16:03
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -105,7 +105,6 @@
105 105  
106 106  The device implements a circuit for active monitoring of the integrity of a high-voltage bus (high voltage interlock loop, HVIL). BMS Main 3.0 outputs a modulated signal into the current loop and controls the current value in it (connector X4). If there is a discrepancy between the measured and required current values, the device opens the power contactors.
107 107  
108 -
109 109  The BMS Main 3.0 device has the following interfaces:
110 110  
111 111  * USB – used to configure device parameters using the ElectricDeviceMonitor software;
... ... @@ -117,5 +117,4 @@
117 117  
118 118  On the device board there is a P2 connector for connecting an expansion communication module: BMS Wi-Fi, BMS GSM or BMS LANmodule. With these modules, user can configure device parameters using the ElectricDeviceMonitor software and transfer accumulated log files with the state of the battery system to a remote server.
119 119  
120 -
121 121  The device can be used as a controller of several battery modules connected in parallel and controlled by other BMS Main 3 devices. To do this, install modified firmware that changes the device type to BMS Main 3X.