Changes for page 4. Firmware update
Last modified by Admin on 2025/03/03 13:18
Summary
-
Page properties (1 modified, 0 added, 0 removed)
Details
- Page properties
-
- Content
-
... ... @@ -1,5 +1,8 @@ 1 -== 1. Introduction == 1 +(% data-numbered-headings-start="4" style="--numbered-headings-start: 3;font-size: 0px;color: rgba(0, 0, 0, 0.0);margin-bottom: 0px; margin-top: 0px;" %) 2 += Firmware update = 2 2 4 +== Introduction == 5 + 3 3 This document describes the steps for updating the BMS Main 2.x firmware. 4 4 5 5 Updating the BMS Main 2.x firmware can be done in the following ways: ... ... @@ -7,7 +7,7 @@ 7 7 * using ElectricDeviceMonitor via Ethernet, CAN or RS-485 bus; 8 8 * using the device web interface via Ethernet or Wi-Fi. 9 9 10 -== 2.Updating via ElectricDeviceMonitor ==13 +== Updating via ElectricDeviceMonitor == 11 11 12 12 The following hardware and software are required: 13 13 ... ... @@ -21,7 +21,7 @@ 21 21 * starting the bootloader; 22 22 * uploading the firmware file to the BMS Main 2.x flash memory. 23 23 24 -=== =2.1.Start the device bootloader ====27 +=== Start the device bootloader === 25 25 26 26 * **via Web Interface**: go to the "Service → Device" section and click on the link "Reset device and start loader": 27 27 ... ... @@ -40,7 +40,7 @@ 40 40 The bootloader will be active for 45 seconds. After this time, control will be transferred again to the main firmware. 41 41 ))) 42 42 43 -=== =2.2.Upload the firmware. ====46 +=== Upload the firmware. === 44 44 45 45 ~1. Launch the ElectricDeviceMonitor’s Updater module: 46 46 ... ... @@ -66,7 +66,7 @@ 66 66 67 67 4. Click the “Update” button **while the device is in bootloader mode**. The process of loading the new firmware into the device memory will begin. 68 68 69 -== 3.Updating via WEB interface ==72 +== Updating via WEB interface == 70 70 71 71 (% class="box warningmessage" %) 72 72 (((