Skip to Content

Changes for page 4. Firmware update

Last modified by Admin on 2025/03/03 13:18
From version 10.1
edited by Admin
on 2024/12/02 16:32
Change comment: There is no comment for this version
To version 12.1
edited by Admin
on 2024/12/11 10:45
Change comment: There is no comment for this version

Summary

Details

Page properties
Title
... ... @@ -1,1 +1,1 @@
1 -BMS Main 2.1 update procedure
1 +4. Firmware update
Parent
... ... @@ -1,1 +1,1 @@
1 -drafts.Firmware.WebHome
1 +drafts.BMS Main 2\.1.WebHome
Content
... ... @@ -1,5 +1,8 @@
1 -== 1. Introduction ==
1 +(% data-numbered-headings-start="4" style="--numbered-headings-start: 3;font-size: 0px;color: rgba(0, 0, 0, 0.0);margin-bottom: 0px; margin-top: 0px;" %)
2 += Firmware update =
2 2  
4 +== Introduction ==
5 +
3 3  This document describes the steps for updating the BMS Main 2.x firmware.
4 4  
5 5  Updating the BMS Main 2.x firmware can be done in the following ways:
... ... @@ -7,7 +7,7 @@
7 7  * using ElectricDeviceMonitor via Ethernet, CAN or RS-485 bus;
8 8  * using the device web interface via Ethernet or Wi-Fi.
9 9  
10 -== 2. Updating via ElectricDeviceMonitor ==
13 +== Updating via ElectricDeviceMonitor ==
11 11  
12 12  The following hardware and software are required:
13 13  
... ... @@ -21,7 +21,7 @@
21 21  * starting the bootloader;
22 22  * uploading the firmware file to the BMS Main 2.x flash memory.
23 23  
24 -==== 2.1. Start the device bootloader ====
27 +=== Start the device bootloader ===
25 25  
26 26  * **via Web Interface**: go to the "Service → Device" section and click on the link "Reset device and start loader":
27 27  
... ... @@ -40,7 +40,7 @@
40 40  The bootloader will be active for 45 seconds. After this time, control will be transferred again to the main firmware.
41 41  )))
42 42  
43 -==== 2.2. Upload the firmware. ====
46 +=== Upload the firmware. ===
44 44  
45 45  ~1. Launch the ElectricDeviceMonitor’s Updater module:
46 46  
... ... @@ -66,7 +66,7 @@
66 66  
67 67  4. Click the “Update” button **while the device is in bootloader mode**. The process of loading the new firmware into the device memory will begin.
68 68  
69 -== 3. Updating via WEB interface ==
72 +== Updating via WEB interface ==
70 70  
71 71  (% class="box warningmessage" %)
72 72  (((