Skip to Content

Changes for page 3.6 Battery protection

Last modified by Admin on 2026/04/24 10:30
From version 49.2
edited by Admin
on 2026/04/02 13:52
Change comment: Renamed back-links.
To version 48.1
edited by Admin
on 2025/04/02 10:08
Change comment: Загрузить новое вложение 1743588519424-405.png

Summary

Details

Page properties
Content
... ... @@ -56,7 +56,7 @@
56 56  * Enable – a flag to enable the protection;
57 57  * Minimum cell voltage, V;
58 58  * Tolerant cell voltage, V;
59 -* Check the open circuit voltage instead of the actual voltage – a flag to use the U,,ocv,, (corrected due to current and cell resistance) cell voltage;
59 +* Check the open circuit voltage instead of the actual voltage – a flag to enable U,,ocv,, correction depending on cell current and resistance;
60 60  * Delay before setting the error, second;
61 61  * Delay before clearing the error, second;
62 62  * Lock the error until the device is reset.
... ... @@ -87,7 +87,7 @@
87 87  * Enable – a flag to enable the protection;
88 88  * Maximum cell voltage, V;
89 89  * Tolerant cell voltage, V;
90 -* Check the open circuit voltage instead of the actual voltage – a flag to use the U,,ocv,, (corrected due to current and cell resistance) cell voltage;
90 +* Check the open circuit voltage instead of the actual voltage – a flag to enable U,,ocv,, correction depending on cell current and resistance;
91 91  * Delay before setting the error, second;
92 92  * Delay before clearing the error, second;
93 93  * Switch off the discharging relay on error – a flag to open the discharging relay when the "Overvoltage" error is generated;
... ... @@ -428,7 +428,7 @@
428 428  
429 429  === Contactor feedback check ===
430 430  
431 -The BMS Main 2.x can receive feedback signals from contactors and detect discrepancy between the control value and the feedback signal. To enable specific contactor protection, one of the discrete input must be set as corresponding contactor feedback signal (see [[Input and output signals>>doc:Battery management systems.EOL devices.BMS Main 2\.1.3\. Configuration.3\.3 Input and output signals.WebHome]]).
431 +The BMS Main 2.x can receive feedback signals from contactors and detect discrepancy between the control value and the feedback signal. To enable specific contactor protection, one of the discrete input must be set as corresponding contactor feedback signal (see [[Input and output signals>>doc:Battery management systems.BMS Main 2\.1.3\. Configuration.3\.3 Input and output signals.WebHome]]).
432 432  
433 433  To change the contactor feedback check parameters, select the menu "Protections → Contactor feedback check":
434 434