Skip to Content

Changes for page 3.6 Battery protection

Last modified by Admin on 2025/04/09 12:25
From version 49.1
edited by Admin
on 2025/04/09 12:25
Change comment: There is no comment for this version
To version 46.2
edited by Admin
on 2025/04/02 10:07
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -21,9 +21,7 @@
21 21  * Tolerant discharging current, А;
22 22  * Delay before setting the error, second;
23 23  * Delay before clearing the error, second;
24 -* Use other delays if the battery is discharging – a flag to enable alternative timings for battery discharging;
25 -* Discharging: Delay before setting the error, second;
26 -* Discharging: Delay before clearing the error, second;
24 +* Use other delays if the battery is discharging – a flag to enable alternative timings for
27 27  * Lock the error until the device is reset – a flag to block the error until the board is restarted.
28 28  
29 29  As a result of operation of the current protection, the "Overcurrent" error is generated.
... ... @@ -56,7 +56,7 @@
56 56  * Enable – a flag to enable the protection;
57 57  * Minimum cell voltage, V;
58 58  * Tolerant cell voltage, V;
59 -* Check the open circuit voltage instead of the actual voltage – a flag to use the U,,ocv,, (corrected due to current and cell resistance) cell voltage;
57 +* Check the open circuit voltage instead of the actual voltage – a flag to enable U,,ocv,, correction depending on cell current and resistance;
60 60  * Delay before setting the error, second;
61 61  * Delay before clearing the error, second;
62 62  * Lock the error until the device is reset.
... ... @@ -87,7 +87,7 @@
87 87  * Enable – a flag to enable the protection;
88 88  * Maximum cell voltage, V;
89 89  * Tolerant cell voltage, V;
90 -* Check the open circuit voltage instead of the actual voltage – a flag to use the U,,ocv,, (corrected due to current and cell resistance) cell voltage;
88 +* Check the open circuit voltage instead of the actual voltage – a flag to enable U,,ocv,, correction depending on cell current and resistance;
91 91  * Delay before setting the error, second;
92 92  * Delay before clearing the error, second;
93 93  * Switch off the discharging relay on error – a flag to open the discharging relay when the "Overvoltage" error is generated;
1743588519424-405.png
Author
... ... @@ -1,1 +1,0 @@
1 -XWiki.admin
Size
... ... @@ -1,1 +1,0 @@
1 -29.7 KB
Content