Skip to Content

Changes for page 3.6 Battery protection

Last modified by Admin on 2025/04/09 12:25
From version 49.1
edited by Admin
on 2025/04/09 12:25
Change comment: There is no comment for this version
To version 44.2
edited by Admin
on 2025/02/19 10:35
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -10,7 +10,7 @@
10 10  
11 11  To change the current protection of the battery, select the menu "Protections → Overcurrent protection":
12 12  
13 -[[image:1743588404359-971.png||data-xwiki-image-style-alignment="center" data-xwiki-image-style-border="true" height="325" width="450"]]
13 +[[image:1732211959984-118.png||data-xwiki-image-style-alignment="center" data-xwiki-image-style-border="true" height="266" width="386"]]
14 14  
15 15   In this section:
16 16  
... ... @@ -21,9 +21,6 @@
21 21  * Tolerant discharging current, А;
22 22  * Delay before setting the error, second;
23 23  * Delay before clearing the error, second;
24 -* Use other delays if the battery is discharging – a flag to enable alternative timings for battery discharging;
25 -* Discharging: Delay before setting the error, second;
26 -* Discharging: Delay before clearing the error, second;
27 27  * Lock the error until the device is reset – a flag to block the error until the board is restarted.
28 28  
29 29  As a result of operation of the current protection, the "Overcurrent" error is generated.
... ... @@ -56,7 +56,7 @@
56 56  * Enable – a flag to enable the protection;
57 57  * Minimum cell voltage, V;
58 58  * Tolerant cell voltage, V;
59 -* Check the open circuit voltage instead of the actual voltage – a flag to use the U,,ocv,, (corrected due to current and cell resistance) cell voltage;
56 +* Check the open circuit voltage instead of the actual voltage – a flag to enable Uocv correction depending on cu;
60 60  * Delay before setting the error, second;
61 61  * Delay before clearing the error, second;
62 62  * Lock the error until the device is reset.
... ... @@ -87,7 +87,6 @@
87 87  * Enable – a flag to enable the protection;
88 88  * Maximum cell voltage, V;
89 89  * Tolerant cell voltage, V;
90 -* Check the open circuit voltage instead of the actual voltage – a flag to use the U,,ocv,, (corrected due to current and cell resistance) cell voltage;
91 91  * Delay before setting the error, second;
92 92  * Delay before clearing the error, second;
93 93  * Switch off the discharging relay on error – a flag to open the discharging relay when the "Overvoltage" error is generated;
1743588404359-971.png
Author
... ... @@ -1,1 +1,0 @@
1 -XWiki.admin
Size
... ... @@ -1,1 +1,0 @@
1 -29.7 KB
Content
1743588519424-405.png
Author
... ... @@ -1,1 +1,0 @@
1 -XWiki.admin
Size
... ... @@ -1,1 +1,0 @@
1 -29.7 KB
Content