Changes for page 3.6 Battery protection

Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -757,10 +757,38 @@
757	757
758	758	* the minimum temperature among all cells of the battery is greater than the “Tolerant cell temperature” value during the “Delay before clearing the signal” time.
759	759
	760	+(% class="box infomessage" %)
	761	+(((
760	760	If there is the "Heater" signal, the heater relay closes and/or a signal is output to the corresponded digital output.
	763	+)))
761	761
762	762	== 3.6.29 Heater (AUX) control ==
763	763
	767	+To change the parameters of the heater control algorithm, select the menu "Protections → Heater (AUX) control":
	768	+
	769	+
	770	+In this section:
	771	+
	772	+* Enable – a flag to enable heater control;
	773	+* Minimum cell temperature, °C;
	774	+* Tolerant cell temperature, °C;
	775	+* Delay before setting the signal, second;
	776	+* Delay before clearing the signal, second;
	777	+* Lock the signal until the device is reset;
	778	+* Switch off the heater relay on errors (Undervoltage, Overcurrent, High temperature, Short circuit or Critical error).
	779	+
	780	+As a result of operating the heating algorithm, the “Heater (AUX)” signal is generated.
	781	+
	782	+Conditions of signal generation:
	783	+
	784	+* The minimum temperature among all cells of the battery is less than the “Minimum cell temperature” value during the “Delay before setting the signal” time.
	785	+
	786	+Conditions for clearing the signal:
	787	+
	788	+* the minimum temperature among all cells of the battery is greater than the “Tolerant cell temperature” value during the “Delay before clearing the signal” time.
	789	+
	790	+If there is the "Heater" signal, the heater relay closes and/or a signal is output to the corresponded digital output.
	791	+
764	764	== 3.6.30 Cooler control ==
765	765
766	766	== 3.6.31 Fault simulation ==