Skip to Content

Changes for page 3.6 Battery protection

Last modified by Admin on 2025/04/09 12:25
From version 4.23
edited by Admin
on 2024/11/21 18:28
Change comment: There is no comment for this version
To version 4.22
edited by Admin
on 2024/11/21 18:27
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -706,59 +706,15 @@
706 706  
707 707  * the battery SOC is greater than the “Tolerant SOC” during the “Delay before clearing the signal” time.
708 708  
709 -The "Low SOC signal" is //indicative //and can be linked to any discrete output of the board.
709 +(% class="box infomessage" %)
710 +(((
711 +The "Low SOC signal" is indicative and can be linked to any discrete output of the board.
712 +)))
710 710  
711 711  == 3.6.27 High charging current signal ==
712 712  
713 -To change the parameters of the generation high-current signal, select the menu "Protections → High charging current signal":
714 -
715 -
716 -In this section:
717 -
718 -* Enable – a flag to enable signal generation;
719 -* Maximum charging current, А;
720 -* Tolerant charging current, А;
721 -* Delay before setting the signal, second;
722 -* Delay before clearing the signal, second;
723 -* Lock the signal until the device is reset.
724 -
725 -Signal generation conditions:
726 -
727 -* the measured current is greater than the “Maximum charging current” value during the “Delay before setting the signal” time.
728 -
729 -Conditions for clearing the signal:
730 -
731 -* the measured current is less than the “Tolerant charging current” value during the “Delay before clearing the signal” time.
732 -
733 -The "High charging current" signal is //indicative //and can be linked to any discrete output of the board.
734 -
735 735  == 3.6.28 Heater control ==
736 736  
737 -To change the parameters of the heater control algorithm, select the menu "Protections → Heater control":
738 -
739 -
740 -In this section:
741 -
742 -* Enable – a flag to enable heater control;
743 -* Minimum cell temperature, °C;
744 -* Tolerant cell temperature, °C;
745 -* Delay before setting the signal, second;
746 -* Delay before clearing the signal, second;
747 -* Lock the signal until the device is reset;
748 -* Switch off the heater relay on errors (Undervoltage, Overcurrent, High temperature, Short circuit or Critical error).
749 -
750 -As a result of operating the heating algorithm, the “Heater” signal is generated.
751 -
752 -Conditions of signal generation:
753 -
754 -* The minimum temperature among all cells of the battery is less than the “Minimum cell temperature” value during the “Delay before setting the signal” time.
755 -
756 -Conditions for clearing the signal:
757 -
758 -* the minimum temperature among all cells of the battery is greater than the “Tolerant cell temperature” value during the “Delay before clearing the signal” time.
759 -
760 -If there is the "Heater" signal, the heater relay closes and/or a signal is output to the corresponded digital output.
761 -
762 762  == 3.6.29 Heater (AUX) control ==
763 763  
764 764  == 3.6.30 Cooler control ==