Skip to Content

Changes for page 3.5 Battery control

Last modified by Admin on 2025/06/11 15:20
From version 26.2
edited by Admin
on 2025/06/11 15:15
Change comment: There is no comment for this version
To version 26.5
edited by Admin
on 2025/06/11 15:19
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -133,11 +133,16 @@
133 133  * Delay before stopping discharging – a time delay T,,off,, before opening the discharging relay, second;
134 134  * Use specific delays before stopping discharging (on errors) – a flag to enable manual settings of time delays T,,off,, for specific errors;
135 135  * Switch off the discharging relay on errors without delay – a flag to protectively open the discharging relay without delay. In the opposite case, when an error is detected, the discharging relay opens always with the delay “Delay before stopping discharging”.
136 +* Control the precharging relay – a flag to enable precharge at discharging;
137 +* Delay before current measurement, millisecond;
136 136  * Precharge time – a duration of closing the precharge relay before closing the discharging relay, millisecond;
137 137  * Precharge current threshold to start discharging – a minimum current value to finish precharging and start discharge, A;
140 +* Keep the precharging relay closed until precharge is finished – a flag to ignore the Precharge time and wait precharging to finish before open precharge relay;
141 +* Delay before clearing the "Precharge error", second – a
142 +* Lock the "Precharge error" until the device is reset
138 138  * Voltage to clear the “Ready to discharge” signal – a threshold U,,ocv,, (corrected due to current and cell resistance) voltage level on the cell, V; if the voltage of any cell is below this level, the “Ready to discharge” signal is cleared;
139 139  * Voltage to reset the “Ready to discharge” signal – a tolerant U,,ocv,, (corrected due to current and cell resistance) voltage level on the cell, V; if all cells voltages are above the tolerant level, the “Ready to discharge” signal is set;
140 -* Treat negative currents as zero currents for generating the "Read y to charge" signal – a flag to disable voltage correction
145 +* Treat negative currents as zero currents for generating the "Ready to charge" signal – a flag to disable voltage correction for "Ready to charge" signal at discharging current;
141 141  
142 142  === Discharging (AUX) control ===
143 143