Changes for page 3.5 Battery control

Last modified by Admin on 2025/03/10 12:50

From version 11.2

edited by Admin
on 2024/12/11 11:21

Change comment: Update document after refactoring.

To version 11.3

edited by Admin
on 2025/01/11 19:01

Change comment: There is no comment for this version

Summary

Page properties

Content

@@ -132,6 +132,7 @@
  * Use specific delays before stopping discharging (on errors) – a flag to enable manual settings of time delays T,,off,, for specific errors;
  * Switch off the discharging relay on errors without delay – a flag to protectively open the discharging relay without delay. In the opposite case, when an error is detected, the discharging relay opens always with the delay “Delay before stopping discharging”.
  * Precharge time – a duration of closing the precharge relay before closing the discharging relay, millisecond;
++* Precharge current threshold to start discharging – a minimum current value to finish precharging and start discharge, A;
  * Voltage to clear the “Ready to discharge” signal – a threshold voltage level on the cell, V; if the voltage of any cell is below this level, the “Ready to discharge” signal is cleared;
  * Voltage to reset the “Ready to discharge” signal – a tolerant voltage level on the cell, V; if all cells voltages are above the tolerant level, the “Ready to discharge” signal is set.