Skip to Content

Changes for page 3.4 Battery parameters

Last modified by Admin on 2025/04/09 12:04
From version 9.3
edited by Admin
on 2024/11/21 16:55
Change comment: There is no comment for this version
To version 8.4
edited by Admin
on 2024/11/21 16:52
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -227,35 +227,10 @@
227 227  
228 228  == 3.4.7 Charge current map ==
229 229  
230 -The BMS Main 2.x board calculates maximum allowable charge current values in respect to SOC and battery temperature, contactor temperature and maximum cell voltage.
231 231  
232 -Calculated currents values are sending to chargers or intellectual loads over the CAN bus.
233 -
234 -To configure parameters for determining the charge current limit, select the menu "Cells → Charge current map":
235 -
236 -[[Charge current map settings>>image:1732208033738-498.png||data-xwiki-image-style-alignment="center" height="655" width="453"]]
237 -
238 -In this section:
239 -
240 -* Enable – a flag to start calculation of the charge current limit;
241 -* Maximum charging current – a maximum allowable value of the charge current (under normal conditions):
242 -* Limit charging current by the battery SOC and temperature – a flag to enable correction of maximum allowable charging current Kcs depending on SOC and temperature;
243 -* Limit charging current by the contactor temperature – a flag to enable correction of maximum allowable charging current Kcc depending on the contactor temperature;
244 -* Limit charging current by the maximum cell voltage - a flag to enable correction of maximum allowable charging current Kcv depending on maximum cell voltage;
245 -* Limit charging current by the maximum cell temperature - a flag to enable correction of maximum allowable charging current Kc depending on maximum cell voltage.
246 -
247 -Value of the charge current limit at given SOC, temperature, contactors temperature and maximum cell voltage is calculated as follows:
248 -
249 -Charging current limit = Maximum charging current × Kcs × Kcc × Kcv
250 -
251 251  == 3.4.8 Discharge current map ==
252 252  
253 -The BMS Main 2.x board calculates maximum allowable discharge current values in respect to SOC and battery temperature, contactor temperature and maximum cell voltage.
254 254  
255 -Calculated currents values are sending to chargers or intellectual loads over the CAN bus.
256 -
257 -To configure parameters for determining the charge current limit, select the menu "Cells → Charge current map":
258 -
259 259  == 3.4.9 SOC correction ==
260 260  
261 261  The BMS Main 2.x board can recalculate the battery SOC after long-term storage or after long-term working in the case when the battery was not charged fully or discharged totally. Recalculation is done based on the tabular dependency Uocv = Uocv (SOC, t) (see section Calculating the state of charge (SOC)).
1732208033738-498.png
Author
... ... @@ -1,1 +1,0 @@
1 -XWiki.admin
Size
... ... @@ -1,1 +1,0 @@
1 -42.7 KB
Content