Changes for page 3.4 Battery parameters

Summary

• Page properties (1 modified, 0 added, 0 removed)
• Attachments (0 modified, 0 added, 1 removed)
  • 1732208033738-498.png

Details

Page properties

Content

...	...	@@ -225,26 +225,10 @@
225	225	* OCV – cell voltage Uocv, V;
226	226	* Resistance – cell resistance, Ohm.
227	227
228		-== 3.4.7 Charge current map ==
229	229
230		-The BMS Main 2.x board calculates maximum allowable charge current values in respect to SOC and battery temperature, contactor temperature and maximum cell voltage.
231	231
232		-Calculated currents values are sending to chargers or intellectual loads over the CAN bus.
	230	+== SOC correction ==
233	233
234		-To configure parameters for determining the charge current limit, select the menu "Cells → Charge current map":
235		-
236		-[[Charge current map settings>>image:1732208033738-498.png||data-xwiki-image-style-alignment="center" height="655" width="453"]]
237		-
238		-== 3.4.8 Discharge current map ==
239		-
240		-The BMS Main 2.x board calculates maximum allowable discharge current values in respect to SOC and battery temperature, contactor temperature and maximum cell voltage.
241		-
242		-Calculated currents values are sending to chargers or intellectual loads over the CAN bus.
243		-
244		-To configure parameters for determining the charge current limit, select the menu "Cells → Charge current map":
245		-
246		-== 3.4.9 SOC correction ==
247		-
248	248	The BMS Main 2.x board can recalculate the battery SOC after long-term storage or after long-term working in the case when the battery was not charged fully or discharged totally. Recalculation is done based on the tabular dependency Uocv = Uocv (SOC, t) (see section Calculating the state of charge (SOC)).
249	249
250	250	To configure parameters for periodically correcting the battery state of charge, select the menu "Cells → SOC correction":

1732208033738-498.png

Author

...	...	@@ -1,1 +1,0 @@
1		-XWiki.admin

Size

...	...	@@ -1,1 +1,0 @@
1		-42.7 KB

Content