Changes for page 3.4 Battery parameters

Summary

• Page properties (1 modified, 0 added, 0 removed)
• Attachments (0 modified, 1 added, 0 removed)
  • 1732208033738-498.png

Details

Page properties

Content

...	...	@@ -225,10 +225,26 @@
225	225	* OCV – cell voltage Uocv, V;
226	226	* Resistance – cell resistance, Ohm.
227	227
	228	+== 3.4.7 Charge current map ==
228	228
	230	+The BMS Main 2.x board calculates maximum allowable charge current values in respect to SOC and battery temperature, contactor temperature and maximum cell voltage.
229	229
230		-== SOC correction ==
	232	+Calculated currents values are sending to chargers or intellectual loads over the CAN bus.
231	231
	234	+To configure parameters for determining the charge current limit, select the menu "Cells → Charge current map":
	235	+
	236	+[[Charge current map settings>>image:1732208033738-498.png||data-xwiki-image-style-alignment="center" height="655" width="453"]]
	237	+
	238	+== 3.4.8 Discharge current map ==
	239	+
	240	+The BMS Main 2.x board calculates maximum allowable discharge current values in respect to SOC and battery temperature, contactor temperature and maximum cell voltage.
	241	+
	242	+Calculated currents values are sending to chargers or intellectual loads over the CAN bus.
	243	+
	244	+To configure parameters for determining the charge current limit, select the menu "Cells → Charge current map":
	245	+
	246	+== 3.4.9 SOC correction ==
	247	+
232	232	The BMS Main 2.x board can recalculate the battery SOC after long-term storage or after long-term working in the case when the battery was not charged fully or discharged totally. Recalculation is done based on the tabular dependency Uocv = Uocv (SOC, t) (see section Calculating the state of charge (SOC)).
233	233
234	234	To configure parameters for periodically correcting the battery state of charge, select the menu "Cells → SOC correction":

1732208033738-498.png

Author

...	...	@@ -1,0 +1,1 @@
	1	+XWiki.admin

Size

...	...	@@ -1,0 +1,1 @@
	1	+42.7 KB

Content