Skip to Content

Changes for page 3.4 Battery parameters

Last modified by Admin on 2025/04/09 12:04
From version 6.3
edited by Admin
on 2024/11/21 16:45
Change comment: There is no comment for this version
To version 6.2
edited by Admin
on 2024/11/21 16:44
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -117,27 +117,11 @@
117 117  
118 118  If the BMS Logic board overheats, then the balancing of the cells connected to this board will not be performed (see Logic high temperature protection).
119 119  
120 -To change the cell balancing parameters, select the menu "Cell → Cell balancing":
120 +[[image:1732207485773-804.png]]
121 121  
122 -[[Cell balancing settings>>image:1732207485773-804.png||data-xwiki-image-style-alignment="center" height="264" width="387"]]
123 123  
124 -In this section:
123 +To change the cell balancing parameters, select the menu "Cell → Cell balancing":
125 125  
126 -* Enable – a flag to enable cell balancing;
127 -* Algorithm – a balancing algorithm:
128 -** Balancing stacks individually;
129 -** Balancing the entire battery;
130 -* Constrain (rule):
131 -** Charging;
132 -** Charging or relaxed;
133 -** Always (regardless of battery state);
134 -* Minimum cell voltage to start balancing, V;
135 -* Balancing threshold, V;
136 -* Start cell discharging – a command to start forced balancing of all battery cells (used for service purposes);
137 -* Stop cell discharging – a command to stop forced balancing of all battery cells (used for service purposes).
138 -
139 -== 3.4.5 Series balancing ==
140 -
141 141  == SOC correction ==
142 142  
143 143  The BMS Main 2.x board can recalculate the battery SOC after long-term storage or after long-term working in the case when the battery was not charged fully or discharged totally. Recalculation is done based on the tabular dependency Uocv = Uocv (SOC, t) (see section Calculating the state of charge (SOC)).