Skip to Content

Changes for page 3.4 Battery parameters

Last modified by Admin on 2026/04/24 10:30
From version 35.10
edited by Admin
on 2026/04/24 10:29
Change comment: Renamed back-links.
To version 35.11
edited by Admin
on 2026/04/24 10:30
Change comment: Renamed back-links.

Summary

Details

Page properties
Content
... ... @@ -170,7 +170,7 @@
170 170  
171 171  The BMS Main 2.x board supports work with two independent (galvanically unrelated) cell series. To monitor the status of two series, two current sensors are used: primary and secondary (AUX). A series of cells must be equivalent: they must have the same number of cells and the same capacity.
172 172  
173 -Since the series of cells can operate at different loads, they must be balanced. For this, the BMS Main 2.x provides two relays: “Balancing series 1” and “Balancing series 2” (see [[Input and output signals>>doc:Battery management systems.BMS Main 2\.1 (End-of-Life).3\. Configuration.3\.3 Input and output signals.WebHome]]), as well as a combined algorithm that considers both the voltage of each series and the charge that these series gave load. “Balancing series 1” and “Balancing series 2” relays are used to connect high-power balancing resistors in parallel with cells series 1 and 2.
173 +Since the series of cells can operate at different loads, they must be balanced. For this, the BMS Main 2.x provides two relays: “Balancing series 1” and “Balancing series 2” (see [[Input and output signals>>doc:Battery management systems.BMS Main 2\.1.3\. Configuration.3\.3 Input and output signals.WebHome]]), as well as a combined algorithm that considers both the voltage of each series and the charge that these series gave load. “Balancing series 1” and “Balancing series 2” relays are used to connect high-power balancing resistors in parallel with cells series 1 and 2.
174 174  
175 175  When charging the battery, balancing is performed based on the voltage of the series. A balancing resistor is connected to the cell series if:
176 176