Skip to Content

Changes for page 3.4 Battery parameters

Last modified by Admin on 2025/04/09 12:04
From version 19.1
edited by Admin
on 2024/12/02 15:15
Change comment: There is no comment for this version
To version 23.1
edited by Admin
on 2024/12/02 15:24
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -45,7 +45,7 @@
45 45  * Scale the final SOC – flag to scale the battery SOC by the following values;
46 46  * Internal SOC corresponding to 0% – battery SOC that sets to be 0%;
47 47  * Internal SOC corresponding to 100% – battery SOC that sets to be 100%.
48 -* Uocv = Uocv(SOC, t °C) – the dependence of the cell open circuit voltage Uocv on SOC and the cell temperature (selected for specific batteries, can be established experimentally – see [[3.4.6 Cell analysis>>doc:||anchor="3.4.6 Cell analysis"]]);
48 +* Uocv = Uocv(SOC, t °C) – the dependence of the cell open circuit voltage Uocv on SOC and the cell temperature (selected for specific batteries, can be established experimentally – see [[3.4.6 Cell analysis>>doc:||anchor="H3.4.6Cellanalysis"]]);
49 49  * Linear zone – linear zone of dependence Uocv = Uocv(SOC, t °C):
50 50  ** Uocv ,,[point 1],, – starting point of the linear zone;
51 51  ** Uocv ,,[point 2],, – end point of the linear zone;
... ... @@ -115,7 +115,7 @@
115 115  * the voltage on the cell is higher than the starting voltage of the balancing;
116 116  * the difference between the cell voltage and the minimum voltage among the cells of the battery is greater than the balancing threshold.
117 117  
118 -If the BMS Logic board overheats, then the balancing of the cells connected to this board will not be performed (see [[3.6.18 Logic high temperature protection>>doc:drafts.BMS Main 2\.1.3\. Configuration.3\.6 Battery protection.WebHome||anchor="3.6.18 Logic high temperature protection"]]).
118 +If the BMS Logic board overheats, then the balancing of the cells connected to this board will not be performed (see [[3.6.18 Logic high temperature protection>>doc:drafts.BMS Main 2\.1.3\. Configuration.3\.6 Battery protection.WebHome||anchor="H3.6.18 Logic high temperature protection"]]).
119 119  
120 120  To change the cell balancing parameters, select the menu "Cell → Cell balancing":
121 121