Skip to Content
Last modified by Admin on 2025/04/09 12:34
From version 8.2
edited by Admin
on 2024/11/21 15:24
Change comment: There is no comment for this version
To version 9.1
edited by Admin
on 2024/11/21 15:59
Change comment: Uploaded new attachment "1732204766138-628.png", version {1}

Summary

Details

Page properties
Content
... ... @@ -126,4 +126,24 @@
126 126  
127 127  To configure the shunt current sensor parameters, select the menu "Signals → Current shunt sensor":
128 128  
129 -[[image:1732202640889-562.png]]
129 +[[Shunt sensor settings>>image:1732202640889-562.png||data-xwiki-image-style-alignment="center" height="342" width="265"]]
130 +
131 +In this section:
132 +
133 +* Settings:
134 +* Enable – a flag to start interaction with BMS Current Sensor (if interaction is enabled then BMS doesn’t use Hall-Effect current sensor which settings are described in the menu "Signals → Current sensor");
135 +* Node ID – an address of BMS Current Sensor in CANopen network;
136 +* Dispatch timeout – timeout of dispatching packages from BMS Current Sensor (if no data is being received from current sensor during this time, the “Shunt offline” flag is set), millisecond;
137 +* Zero level threshold – T,,0,, level, A (if module of instantaneous current (I,,I,,) which is received from shunt sensor is lower than T,,0,,, BMS will assume that current flowing through the battery is zero);
138 +* Mean level threshold – TM level, A (if module of instantaneous current (I,,I,,) which is received from shunt sensor is between T,,M,, and T,,0,,, BMS will use mean value of current I,,M,,; if I,,I,, is greater than T,,M,,, BMS will use instantaneous value of current I,,I,,);
139 +* Invert – a flag to invert current values;
140 +* Sensor state:
141 +** Online – a flag showing that the communication with the BMS Current Sensor is established;
142 +** Errors – a list of internal errors of the shunt sensor;
143 +** Current – an instantaneous value of current measured by the BMS Current Sensor, A (measuring frequency is 50 Hz);
144 +** Current (mean) – a mean value of current measured by the BMS Current Sensor, A (the value is calculated as an average of 100 consistent measurements);
145 +** Temperature – a temperature of the shunt sensor, °C.
146 +
147 +=== 3.3.4 Temperature sensor ===
148 +
149 +To configure the temperature sensor parameters, select the menu "Signals → Temperature sensor":
1732204766138-628.png
Author
... ... @@ -1,0 +1,1 @@
1 +XWiki.admin
Size
... ... @@ -1,0 +1,1 @@
1 +7.9 KB
Content