Skip to Content
Last modified by Admin on 2025/04/09 12:34
From version 4.2
edited by Admin
on 2024/11/21 15:14
Change comment: There is no comment for this version
To version 3.4
edited by Admin
on 2024/11/21 15:12
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -57,39 +57,3 @@
57 57  )))
58 58  
59 59   To configure the input discrete and analog signals, select the menu "Signals → Input signals":
60 -
61 -[[Input signals section>>image:1732201986070-992.png||data-xwiki-image-style-alignment="center" height="290" width="272"]]
62 -
63 -
64 -The order of the numbering of the discrete and analog inputs corresponds to the order of the numbering on the board.
65 -
66 -In this section:
67 -
68 -* Discrete inputs:
69 -** No input;
70 -** Battery cover – a signal from the battery cover trailer;
71 -** Charger connected – a signal from the charger connector;
72 -** Power up/down request – a signal from the external power monitor which is used for proper powering BMS up or down;
73 -** Inhibit charging – a command to open the charging relay;
74 -** Inhibit discharging – a command to open the discharging relay;
75 -** CH contactor feedback – a feedback signal from the charging contactor;
76 -** DCH contactor feedback – a feedback signal from the discharging contactor;
77 -** Insulation status – a signal from an external insulation monitoring device;
78 -** Charge request – a request for closing the charging contactor;
79 -** Precharge request – a request for closing the precharging contactor;
80 -** Discharge request – a request for closing the discharging contactor;
81 -** PCH contactor feedback – a feedback signal from the precharging contactor;
82 -** CH/DCH contactor feedback – a feedback signal from the charging/discharging contactor;
83 -** Main contactor feedback – a feedback signal from the main contactor.
84 -* Analog inputs:
85 -** No input;
86 -** Current sensor;
87 -** Current zero level;
88 -** Temperature sensor;
89 -** Humidity sensor;
90 -** Current sensor (AUX) – additional current sensor for measuring current in a series of cells;
91 -** Current zero level (AUX) – zero level bus for additional current sensor.
92 -
93 -3.3.2
94 -
95 -After selecting the assignment of the analog inputs, you need to configure the parameters of the sensors connected to the board.
1732201986070-992.png
Author
... ... @@ -1,1 +1,0 @@
1 -XWiki.admin
Size
... ... @@ -1,1 +1,0 @@
1 -24.0 KB
Content