Changes for page 3.3 Input and output signals

Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -71,12 +71,11 @@
71	71	** Parallel sensors – additional (AUX) sensor is located in parallel circuit. Final current is estimated as sum of both sensors values;
72	72	** Serial sensors – additional (AUX) sensor is located on the same circuit. Final current is estimated as average of both sensors values;
73	73	** Separated sensors – additional (AUX) sensor is used to measure the current in second series of cells (см. [[Series balancing>>url:https://docs.movicomelectric.com/bin/view/Battery%20management%20systems/BMS%20Main%202.1/3.%20Configuration/3.4%20Battery%20parameters/?HSeriesbalancing#HSeriesbalancing]]);
74		-** Dual range sensor – main sensor is a dual range sensor. Transition to a second range measurements is done by a "Current threshold" parameter;
75		-** Separate dual range sensors – main and additional sensors are dual range sensors, located on the same line. Since this mode requires all analog inputs, the modification of BMS Main board is required;
	74	+** Dual range sensor – main sensor is a dual range sensor. Transition betwe;
	75	+** Separate dual range sensors – auxiliary sensor and main sensor are dual range sensors, located on the same line (P13 header modification is required!);
76	76	* Nominal current – rated current of the sensor according to the datasheet, А;
77	77	* Sensitivity – sensitivity of the current sensor according to the datasheet, V / I,,nominal.,,;
78		-* Current threshold – a value below which current is measured by low-current range of dual range sensor, A;
79		-* Voltage, corresponding 0A – calibrated zero level of the current sensor output, V;
	78	+* Zero level – level "0A" of the current sensor, V;
80	80	* Multiply the charging current (experimental) – experimental flag for scaling the charging current by given multiplier;
81	81	* Multiplier – charging current multiplier;
82	82