Skip to Content
Last modified by Admin on 2026/06/29 16:25
From version 30.26
edited by Admin
on 2026/06/29 16:22
Change comment: There is no comment for this version
To version 30.24
edited by Admin
on 2026/06/29 16:20
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -72,11 +72,10 @@
72 72  ** Serial sensors – additional (AUX) sensor is located on the same circuit. Final current is estimated as average of both sensors values;
73 73  ** Separated sensors – additional (AUX) sensor is used to measure the current in second series of cells (см. [[Series balancing>>url:https://docs.movicomelectric.com/bin/view/Battery%20management%20systems/BMS%20Main%202.1/3.%20Configuration/3.4%20Battery%20parameters/?HSeriesbalancing#HSeriesbalancing]]);
74 74  ** Dual range sensor – main sensor is a dual range sensor. Transition to a second range measurements is done by a "Current threshold" parameter;
75 -** Separate dual range sensors – main and additional sensors are dual range sensors, located on the same line. Since this mode requires all analog inputs, the modification of BMS Main board is required;
75 +** Separate dual range sensors – main and additional sensorsand main sensor are dual range sensors, located on the same line (P13 header modification is required!);
76 76  * Nominal current – rated current of the sensor according to the datasheet, А;
77 77  * Sensitivity – sensitivity of the current sensor according to the datasheet, V / I,,nominal.,,;
78 -* Current threshold – a value below which current is measured by low-
79 -* Voltage, corresponding 0A – calibrated zero level of the current sensor, V;
78 +* Zero level – level "0A" of the current sensor, V;
80 80  * Multiply the charging current (experimental) – experimental flag for scaling the charging current by given multiplier;
81 81  * Multiplier – charging current multiplier;
82 82