Changes for page 3.3 Input and output signals

Last modified by Admin on 2026/06/29 16:25

From version 30.25

edited by Admin
on 2026/06/29 16:21

Change comment: There is no comment for this version

To version 30.26

edited by Admin
on 2026/06/29 16:22

Change comment: There is no comment for this version

Summary

Page properties

Content

@@ -75,8 +75,8 @@
  ** Separate dual range sensors – main and additional sensors are dual range sensors, located on the same line. Since this mode requires all analog inputs, the modification of BMS Main board is required;
  * Nominal current – rated current of the sensor according to the datasheet, А;
  * Sensitivity – sensitivity of the current sensor according to the datasheet, V / I,,nominal.,,;
--* Current threshold
--* Zero level – level "0A" of the current sensor, V;
++* Current threshold – a value below which current is measured by low-
++* Voltage, corresponding 0A – calibrated zero level of the current sensor, V;
  * Multiply the charging current (experimental) – experimental flag for scaling the charging current by given multiplier;
  * Multiplier – charging current multiplier;