Skip to Content

Wiki source code of 3. Configuration

Version 1.1 by Admin on 2024/12/02 14:20

Show last authors

author	version	line-number	content
		1	== 3.1 Setting device address ==
		2
		3	The address is set by the SWD1 switch. Address 0 (all switches are raised) is incorrect.
		4
		5	The address from 1 to 20 is set on the switches as a binary number. The ON state (bottom position) corresponds to a single digit value. The switch with the number 1 corresponds to the lower order. The address is read by the device at initialization, so to change the address it is necessary to switch off and turn on the device.
		6
		7	To select the proper device address, use the following table:
		8
		9	\|(% rowspan="2" %)Address\|(% colspan="6" %)SWD1
		10	\|1\|2\|3\|4\|5\|6
		11	\|1\|ON\|OFF\|OFF\|OFF\|OFF\|OFF
		12	\|2\|OFF\|ON\|OFF\|OFF\|OFF\|OFF
		13	\|3\|ON\|ON\|OFF\|OFF\|OFF\|OFF
		14	\|4\|OFF\|OFF\|ON\|OFF\|OFF\|OFF
		15	\|5\|ON\|OFF\|ON\|OFF\|OFF\|OFF
		16	\|6\|OFF\|ON\|ON\|OFF\|OFF\|OFF
		17	\|7\|ON\|ON\|ON\|OFF\|OFF\|OFF
		18	\|8\|OFF\|OFF\|OFF\|ON\|OFF\|OFF
		19	\|9\|ON\|OFF\|OFF\|ON\|OFF\|OFF
		20	\|10\|OFF\|ON\|OFF\|ON\|OFF\|OFF
		21	\|11\|ON\|ON\|OFF\|ON\|OFF\|OFF
		22	\|12\|OFF\|OFF\|ON\|ON\|OFF\|OFF
		23	\|13\|ON\|OFF\|ON\|ON\|OFF\|OFF
		24	\|14\|OFF\|ON\|ON\|ON\|OFF\|OFF
		25	\|15\|ON\|ON\|ON\|ON\|OFF\|OFF
		26	\|16\|OFF\|OFF\|OFF\|OFF\|ON\|OFF
		27	\|17\|ON\|OFF\|OFF\|OFF\|ON\|OFF
		28	\|18\|OFF\|ON\|OFF\|OFF\|ON\|OFF
		29	\|19\|ON\|ON\|OFF\|OFF\|ON\|OFF
		30	\|20\|OFF\|OFF\|ON\|OFF\|ON\|OFF
		31
		32	Address selection requirements:
		33
		34	* it is necessary to use consecutive addresses, without omissions;
		35	* it is necessary to use addresses from 1 to 20;
		36	* when choosing an address, follow the rule: a device with a smaller address serves less potential;
		37	* to facilitate subsequent maintenance, it is recommended to create a schematic indicating the location of the BMS Logic 2.0 and their addresses.