Skip to Content
Last modified by Admin on 2025/03/18 13:04
From version 4.1
edited by Admin
on 2024/12/04 11:26
Change comment: There is no comment for this version
To version 2.1
edited by Admin
on 2024/12/02 14:36
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -27,7 +27,7 @@
27 27  (% class="box warningmessage" %)
28 28  (((
29 29  **Attention!**
30 -All headers are shown from the device side!
30 +All connectors are shown from the device side!
31 31  )))
32 32  
33 33  === 2.2.1 X1 – header for cells and temperature sensors[[image:1733148735564-962.png||data-xwiki-image-style-alignment="center" height="84" width="218"]] ===
... ... @@ -88,14 +88,12 @@
88 88  1. Connect the BMS Logic 2.0 to each other (X2 -> X3).
89 89  1. Install jumper P1 on the last BMS Logic 2.0 in the chain.
90 90  
91 -(% class="box infomessage" %)
92 -(((
93 -**Recommendations:**
94 -~1. The total cable length (the sum of the lengths of all cables) between the BMS Main and the last BMS Logic 2.0 should not exceed 500 meters.
95 -2. Make all connections with the same cable.
96 -3. For a total cable length of more than 10 meters use twisted pair with the 120 Ohm wave impedance.
97 -)))
91 +Recommendations:
98 98  
93 +1. The total cable length (the sum of the lengths of all cables) between the BMS Main and the last BMS Logic 2.0 should not exceed 500 meters.
94 +1. Make all connections with the same cable.
95 +1. For a total cable length of more than 10 meters use twisted pair with the 120 Ohm wave impedance.
96 +
99 99  === 2.4.2 Connecting battery cells ===
100 100  
101 101  To connect the battery cells, follow the picture below. Incorrect connection of the cells can damage the BMS Logic 2.0.