Skip to Content

Changes for page 4. Firmware update

Last modified by Admin on 2025/01/09 10:20
From version 2.2
edited by Admin
on 2024/12/04 10:46
Change comment: Update document after refactoring.
To version 6.1
edited by Admin
on 2025/01/09 10:20
Change comment: There is no comment for this version

Summary

Details

Page properties
Parent
... ... @@ -1,1 +1,1 @@
1 -drafts.BMS Logic 12.WebHome
1 +Battery management systems.BMS Logic 12.WebHome
Content
... ... @@ -1,5 +1,8 @@
1 -== 1. Introduction ==
1 +(% data-numbered-headings-start="4" style="--numbered-headings-start: 3;font-size: 0px;color: rgba(0, 0, 0, 0.0);margin-bottom: 0px; margin-top: 0px;" %)
2 += Firmware update =
2 2  
4 +== Introduction ==
5 +
3 3  The document describes the steps to update the BMS Logic 12/18 firmware.
4 4  
5 5  Required hardware and software:
... ... @@ -7,11 +7,10 @@
7 7  * PC or laptop with Windows 10 or newer;
8 8  * BMS USB-RS485 – a device to power and communicate with the BMS Logic 12/18;
9 9  * [[ElectricDeviceMonitor>>https://movicomelectric.com/wa-data/public/site/app/ElectricDeviceMonitorSETUP.exe]] – a software to monitor and configure devices by Movicom Electric;
13 +* Firmware (*.srec) – a new firmware for the BMS Logic 12/18.
10 10  
11 -Firmware (*.srec) – a new firmware for the BMS Logic 12/18.
15 +== Updating process ==
12 12  
13 -== 2. Updating process ==
14 -
15 15  Follow the steps below:
16 16  
17 17  ~1. Connect the BMS Logic 12 or 18 to the BMS USB-RS485 with harnesses:
... ... @@ -47,8 +47,10 @@
47 47  
48 48  **10. Boot the device to go into the bootloader mode.**
49 49  
50 -**10a.** For the **BMS Logic 12 v3.3 and older** or **BMS Logic 18 v3.2 and older** (which have an address switch onboard), move all switches to the OFF state so the address is 0. The device will show that it is in the bootloader mode by flashing the DS1 with 0.5Hz frequency.
52 +**10a.** For the **BMS Logic 12 v3.3 and older** or **BMS Logic 18 v3.2 and older** (which have an address switch onboard):
51 51  
54 +* Move all switches to the OFF state so the address is 0. The device will show that it is in the bootloader mode by flashing the DS1 with 0.5Hz frequency.
55 +
52 52  **10b.** For the **BMS Logic 12 v3.4 and newer** or **BMS Logic 18 v3.3 and newer** do the following steps:
53 53  
54 54  * In the ElectricDeviceMonitor, select the menu “Tasks – Monitor - BMS Logic 12/18 3.x”: