Skip to Content

Changes for page 4. Firmware update

Last modified by Admin on 2025/01/09 10:20
From version 2.1
edited by Admin
on 2024/12/02 16:27
Change comment: There is no comment for this version
To version 5.1
edited by Admin
on 2024/12/12 16:48
Change comment: There is no comment for this version

Summary

Details

Page properties
Title
... ... @@ -1,1 +1,1 @@
1 -BMS Logic 12/18 update procedure
1 +4. Firmware update
Parent
... ... @@ -1,1 +1,1 @@
1 -drafts.Firmware.WebHome
1 +Battery management systems.BMS Logic 12.WebHome
Content
... ... @@ -1,5 +1,8 @@
1 -== 1. Introduction ==
1 +(% data-numbered-headings-start="4" style="--numbered-headings-start: 3;font-size: 0px;color: rgba(0, 0, 0, 0.0);margin-bottom: 0px; margin-top: 0px;" %)
2 += Firmware update =
2 2  
4 +== Introduction ==
5 +
3 3  The document describes the steps to update the BMS Logic 12/18 firmware.
4 4  
5 5  Required hardware and software:
... ... @@ -10,7 +10,7 @@
10 10  
11 11  Firmware (*.srec) – a new firmware for the BMS Logic 12/18.
12 12  
13 -== 2. Updating process ==
16 +== Updating process ==
14 14  
15 15  Follow the steps below:
16 16  
... ... @@ -47,8 +47,10 @@
47 47  
48 48  **10. Boot the device to go into the bootloader mode.**
49 49  
50 -**10a.** For the **BMS Logic 12 v3.3 and older** or **BMS Logic 18 v3.2 and older** (which have an address switch onboard), move all switches to the OFF state so the address is 0. The device will show that it is in the bootloader mode by flashing the DS1 with 0.5Hz frequency.
53 +**10a.** For the **BMS Logic 12 v3.3 and older** or **BMS Logic 18 v3.2 and older** (which have an address switch onboard):
51 51  
55 +* Move all switches to the OFF state so the address is 0. The device will show that it is in the bootloader mode by flashing the DS1 with 0.5Hz frequency.
56 +
52 52  **10b.** For the **BMS Logic 12 v3.4 and newer** or **BMS Logic 18 v3.3 and newer** do the following steps:
53 53  
54 54  * In the ElectricDeviceMonitor, select the menu “Tasks – Monitor - BMS Logic 12/18 3.x”: