Skip to Content

Changes for page 3. Configuration

Last modified by Admin on 2024/12/11 11:19
From version 1.1
edited by Admin
on 2024/12/02 13:25
Change comment: There is no comment for this version
To version 2.1
edited by Admin
on 2024/12/02 13:26
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -12,7 +12,7 @@
12 12  
13 13  === 3.1.1 Communication and power cable ===
14 14  
15 -[[image:1733145551342-738.png||data-xwiki-image-style-alignment="center" height="214" width="389"]]
15 +[[image:1733145551342-738.png||data-xwiki-image-style-alignment="center" height="206" width="375"]]
16 16  
17 17  The wires of the communication and power cable must be connected according to the following table:
18 18  
... ... @@ -55,8 +55,16 @@
55 55  [[image:1733145551346-396.png||data-xwiki-image-style-alignment="center" height="324" width="296"]]
56 56  
57 57  
58 -Select the following settings to connect to the BMS Logic 12: 115200 bps, 8 bits, no parity, 1 stop bit, device address 247. The address 247 is a service address that the device will always answer.
58 +Set the following settings to connect to the BMS Logic 12:
59 59  
60 +* 115200 bps,
61 +* 8 bits,
62 +* no parity,
63 +* 1 stop bit,
64 +* device address 247.
65 +
66 +The address 247 is a service address that the device will always answer.
67 +
60 60  [[image:1733145551347-494.png||data-xwiki-image-style-alignment="center" height="242" width="439"]]
61 61  
62 62  Check the connection with the BMS Logic 12 is established.