Skip to Content
Last modified by Admin on 2025/03/18 13:04
From version 6.1
edited by Admin
on 2024/12/02 14:53
Change comment: There is no comment for this version
To version 8.1
edited by Admin
on 2024/12/03 13:05
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -98,7 +98,7 @@
98 98  
99 99  (% class="box infomessage" %)
100 100  (((
101 -**Note: **There is no SWD1 switch in the recent revisions of the BMS Logic 12. The device address must be configured in the settings (see the section [[3.** **Configuration procedure>>doc:drafts.BMS Logic 12.3\. Configuration.WebHome]]).
101 +**Note: **There is no SWD1 switch in the recent revisions of the BMS Logic 12. The device address must be configured in the settings (see the section [[3. Configuration>>doc:drafts.BMS Logic 12.3\. Configuration.WebHome]]).
102 102  )))
103 103  
104 104  === 2.3.2 SWD2 – RS-485 termination resistor switch ===
... ... @@ -154,3 +154,6 @@
154 154  === 2.4.3 Connecting thermistors ===
155 155  
156 156  Thermistors should be fastened to the cells, excluding short circuits to the cell terminals (for example, isolate thermistors with heat shrink). For reliable operation, it is recommended to use all thermistors (a temperature sensor per cell).
157 +
158 +
159 +[[image:1733231119798-210.jpeg||data-xwiki-image-style-alignment="center" height="408" width="539"]]
1733231119798-210.jpeg
Author
... ... @@ -1,0 +1,1 @@
1 +XWiki.admin
Size
... ... @@ -1,0 +1,1 @@
1 +109.2 KB
Content