Skip to Content

Changes for page 5. Firmware update

Last modified by Admin on 2025/02/28 11:48
From version 13.2
edited by Admin
on 2025/02/28 11:32
Change comment: There is no comment for this version
To version 13.3
edited by Admin
on 2025/02/28 11:34
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -19,7 +19,7 @@
19 19  
20 20  ~1. Connect the BMS IMD to the USB-CAN adapter.
21 21  
22 -2. Move switches of the  to the following positions:
22 +2. If BMS USB-CAN used, move switches of the  to the following positions:
23 23  
24 24  * 120 Ohm – “I”;
25 25  * +5V – “0”.
... ... @@ -26,9 +26,9 @@
26 26  
27 27  3. Connect the USB-CAN adapter to a PC.
28 28  
29 -4. Move the switch “+5V” of the BMS USB-CAN to “I”. Check that the led of the BMS IMD is blinking.
29 +4. Power up the BMS IMD device. Check that the led of the BMS IMD is blinking.
30 30  
31 -5. Open the Device Manager* and determine a name of an appeared serial port (Click the right mouse button on the Start menu and select the “Device Manager” item):
31 +5. If BMS USB-CAN used, open the Device Manager and determine a name of an appeared serial port (Click the right mouse button on the Start menu and select the “Device Manager” item):
32 32  
33 33  [[image:Battery management systems.BMS Logic 12.4\. Firmware update.WebHome@1733156153285-215.png||data-xwiki-image-style-alignment="center" height="377" width="382"]]
34 34  
... ... @@ -38,7 +38,7 @@
38 38  
39 39  [[image:Battery management systems.BMS Logic 12.4\. Firmware update.WebHome@1733156153290-392.png||data-xwiki-image-style-alignment="center" height="320" width="296"]]
40 40  
41 -8. Select the "CAN transport (BMS USB-CAN) (1.0.0)" in a drop-down list and click the “Settings” button to configure the adapter:
41 +8. Select the сщккуыз in a drop-down list and click the “Settings” button to configure the adapter:
42 42  
43 43  * select port name that corresponds to the BMS USB-CAN;
44 44  * set 250 kbit/s baud rate.