Changes for page 5. Firmware update

Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -16,26 +16,26 @@
16	16
17	17	Follow the steps below:
18	18
19		-~1. Connect the BMS Display to the BMS USB-CAN with harnesses:
	19	+~1. Connect the BMS Display to the BMS USB-CAN.
20	20
21	21	2. Move switches of the BMS USB-CAN to the following positions:
22	22
23	23	* 120 Ohm – “I”;
24		-* +5V – “1”.
	24	+* +5V – “0”.
25	25
26		-3. Connect the BMS USB-RS485 to a PC.
	26	+3. Connect the BMS USB-CAN to a PC.
27	27
28		-4. Move the switches “Cells” and “+5V” of the BMS USB-RS485 to “I”. Check that the led “DS1” of the BMS Logic 12/18 is blinking.
	28	+4. Move the switch “+5V” of the BMS USB-CAN to “I”. Check that the led of the BMS Display is blinking.
29	29
30	30	5. Open the Device Manager* and determine a name of an appeared serial port (Click the right mouse button on the Start menu and select the “Device Manager” item):
31	31
32		-[[image:1733156153285-215.png||data-xwiki-image-style-alignment="center" height="377" width="382"]]
	32	+[[image:Battery management systems.BMS Logic 12.4\. Firmware update.WebHome@1733156153285-215.png||data-xwiki-image-style-alignment="center" height="377" width="382"]]
33	33
34	34	6. Install and launch the ElectricDeviceMonitor.
35	35
36	36	7. Click the “Updater” button:
37	37
38		-[[image:1733156153290-392.png||data-xwiki-image-style-alignment="center" height="320" width="296"]]
	38	+[[image:Battery management systems.BMS Logic 12.4\. Firmware update.WebHome@1733156153290-392.png||data-xwiki-image-style-alignment="center" height="320" width="296"]]
39	39
40	40	8. Select the transport “Serial port transport (1.0.0)” and click the “Settings” button to configure the serial port: select a port name that corresponds to the BMS USB-RS485 and 115200 kbps baud rate.
41	41