Skip to Content

Changes for page 3. Configuration

Last modified by Admin on 2025/06/23 13:30
From version 13.1
edited by Admin
on 2025/06/23 13:30
Change comment: There is no comment for this version
To version 11.1
edited by Admin
on 2025/03/03 17:35
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -109,7 +109,6 @@
109 109  ** Timeout error – timeout of transition process of measurement;
110 110  ** Anomaly error – the device cannot measure resistance, for example, due to a poor connection to the chassis;
111 111  ** Self test error;
112 -** Chassis break;
113 113  * Insulation status:
114 114  ** No data;
115 115  ** Ok;
... ... @@ -117,9 +117,10 @@
117 117  ** Alarm – resistance is lower than the Alarm resistance;
118 118  * Measurement state – state of measurement procedure:
119 119  ** Idle;
120 -** Bus voltage check;
121 -** Chassis connection;
122 -** Bias resistor connection;
119 +** Chassis connection – chassis is connecting to measuring circuit;
120 +** First stage;
121 +** Offset connection – offset resistors are connecting to measuring circuit;
122 +** Second stage;
123 123  * Resistance calculated – a flag showing that the insulation resistance is calculated;
124 124  * Resistance plus – resistance value between positive line and chassis, Ohm;
125 125  * Resistance minus – resistance value between negative line and chassis, Ohm;