Skip to Content

Changes for page 3. Configuration

Last modified by Admin on 2025/06/23 13:30
From version 10.1
edited by Admin
on 2025/02/28 12:46
Change comment: There is no comment for this version
To version 13.1
edited by Admin
on 2025/06/23 13:30
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -20,8 +20,16 @@
20 20  
21 21  and select the “Launch monitor” button.
22 22  
23 -When connected, the device asks for an access password. For the "User" account, the default password is "user" (without quotes).
23 +When connected, the device asks for an access password.
24 24  
25 +Below is the list of available users. Default passwords can be changed in "Device -> Change password" menu.
26 +
27 +|=User|=Default Password|=Description
28 +|Guest|guest|Guest access to view battery state. No permissions to change and view any settings
29 +|User|user|A common user access with permissions to change almost all the settings
30 +|Service|- (by request)|A service account for battery manufacturers. Has access to some additional settings
31 +|Manufacturer|-|This account is used by BMS manufacturer and not accessible for others
32 +
25 25  [[image:1734009713287-917.png||data-xwiki-image-style-alignment="center" data-xwiki-image-style-border="true" height="381" width="600"]]
26 26  
27 27  After successful authentication, the device will send settings and state profiles, which will be displayed as two tabs: "Settings" and "State":
... ... @@ -101,6 +101,7 @@
101 101  ** Timeout error – timeout of transition process of measurement;
102 102  ** Anomaly error – the device cannot measure resistance, for example, due to a poor connection to the chassis;
103 103  ** Self test error;
112 +** Chassis break;
104 104  * Insulation status:
105 105  ** No data;
106 106  ** Ok;
... ... @@ -108,10 +108,9 @@
108 108  ** Alarm – resistance is lower than the Alarm resistance;
109 109  * Measurement state – state of measurement procedure:
110 110  ** Idle;
111 -** Chassis connection – chassis is connecting to measuring circuit;
112 -** First stage;
113 -** Offset connection – offset resistors are connecting to measuring circuit;
114 -** Second stage;
120 +** Bus voltage check;
121 +** Chassis connection;
122 +** Bias resistor connection;
115 115  * Resistance calculated – a flag showing that the insulation resistance is calculated;
116 116  * Resistance plus – resistance value between positive line and chassis, Ohm;
117 117  * Resistance minus – resistance value between negative line and chassis, Ohm;