Skip to Content

Changes for page 3. Configuration

Last modified by Admin on 2025/02/27 16:44
From version 4.11
edited by Admin
on 2025/02/27 15:16
Change comment: There is no comment for this version
To version 4.12
edited by Admin
on 2025/02/27 15:17
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -1,7 +1,7 @@
1 1  (% data-numbered-headings-start="3" style="--numbered-headings-start: 2;font-size: 0px;color: rgba(0, 0, 0, 0.0);margin-bottom: 0px; margin-top: 0px;" %)
2 2  = Configuration =
3 3  
4 -The BMS Display 1.x is configured over the CAN bus (P3, P4 or P5 headers can be used). The device is a slave in the CANopen network.
4 +The BMS Display is configured over the CAN bus (P3, P4 or P5 headers can be used). The device is a slave in the CANopen network.
5 5  
6 6  The default settings to connect to the BMS Display 1.x are:
7 7  
... ... @@ -48,7 +48,7 @@
48 48  
49 49  * CANopen Node ID – an identifier of the device in the CANopen network (20 by default);
50 50  * CAN baud rate – CAN bus speed, kbps;
51 -* Device type
51 +* Device type – a type of controller connected. Since firmware v1.5.0 BMS Display automatically detects device type;
52 52  * BMS Main Node ID – an identifier of the BMS controller in the CANopen network (32 by default);
53 53  * Heartbeat – a flag for sending Heartbeat messages;
54 54  * Heartbeat period – a period of sending Heartbeat messages, millisecond;